Tribest SD-S9150-B Gebrauchs- und Pflegehandbuch PDF herunterladen (Seite 14)

OPERATING INSTRUCTIONS

For your safety and to protect your Tribest Sedona Combo, please follow the instructions

below:

1. Always keep the Tribest Sedona Combo on a level surface.

• Keep the Tribest Sedona Combo at least 10 cm away from walls, other appliances or furniture.

2. Open the door to insert trays into the Tribest Sedona Combo. Hold the tray in the horizontal

position and push the tray into the proper slots.

• Place the food evenly and neatly on each tray as close as possible (remember dehydrating

removes water and/or shrinks food). For best results, cut the food into even sizes and thickness.

• It is recommended to use separate trays for each type of food.

• You may dehydrate up to 9 trays simultaneously.

• For 4-5 trays of dehydrated recipes, use the upper compartment for best results. The white

plastic dividers on the side of the Sedona Combo now help as a simple visual device to

separate upper and lower compartments.

• Double check whether all the trays are properly loaded.

3. Plug into an outlet that has 10-amp capacity.

4. Turn the main switch ON.

5. There are three settings to choose with the Sedona Combo:

• TWO-STAGE SEQUENTIAL TEMPERATURE-TIMER (TST) Use Only

The Two-Stage Sequential Temperature-Timer (TST), a two-phase combo mode that allows for both

FAST mode and RAW mode to be applied sequentially. This is the default setting of the Sedona

Combo when it is turned on.

1) Turn the Sedona Combo on, both the RED and GREEN lights to the right of the MODE button

will be lit. (Red=FAST mode, Green=RAW mode.)

2) Press the °F/°C button to choose Fahrenheit or Celsius.

3) Press the SET button to set FAST mode to your desired temperature using the UP/DOWN 10

or 1 buttons.

4) Press SET again to set the desired time using the UP/DOWN 10 or 1 buttons for FAST mode.

5) Press SET again to set the desired temperature using the UP/DOWN 10 or 1 buttons for RAW

mode.

6) Press SET again to set the desired time using the UP/DOWN 10 or 1 buttons for RAW mode.

7) Press SET to nalize settings.

8) Press the TRAY button to choose the upper, lower, or both drying compartments.

9) Press the START/PAUSE button to begin operation.

NOTE: During TST mode operation, the upper RED light blinks while the Sedona Combo rst

operates at the higher temperature for the set amount of time; and then, the lower GREEN

light blinks, when the temperature automatically lowered to the second setting for the remaining

dehydrating time.

• FAST Mode Use Only

This setting holds and maintains a higher temperature (e.g. 155°F) for faster dehydrating. The

temperature in the dehydration chamber may uctuate above and below the set temperature as the

heating elements cycle on and off.

1) Set the Sedona Combo to FAST mode by pressing the MODE button once to change the

default Two-Stage Sequential Temperature-Timer (TST) to FAST mode. (A RED light lit to the

upper right of the MODE button indicates that the Sedona Combo is set at FAST mode.)

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 81 82

Kommentare zu diesen Handbüchern

Keine Kommentare

Tribest SD-S9150-B Gebrauchs- und Pflegehandbuch Seite 14

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Haushaltsfans Tribest SD-S9150-B